Taking Up Strut Pin Slop (If Jt Strong Arm Stabilizers Are Installed Only); Reconnecting The Unit To A Tow Vehicle; Truck Hauler Operation (Manual Only) - Lippert Components Ground Control 2.0 Master Owner's Manual

Taking Up Strut Pin Slop (If JT Strong Arm Stabilizers Are Installed ONLY)

1.
Ensure the leveling process has completed. LCD screen should read "Level Jacks: Down" (Fig. 3).
2.
Push "FRONT" button (Fig. 3A) momentarily until front stabilizer pins are tight.
3. Enter manual mode, then push "REAR" button (Fig. 3B) momentarily until rear stabilizer pins are tight.
4.
Push "ON/OFF" button (Fig. 3C) to turn system off.

Reconnecting the Unit to A Tow Vehicle

1.
Be sure main power switch is "ON."
2. Loosen J.T. Strong Arm Stabilizer "T" handles (if applicable).
3.
Push Touch Pad "ON/OFF" button to turn system on.
4.
Push "UP ARROW" to scroll to AUTO RETRACT REAR JACKS and push "ENTER." Rear jacks will fully
retract and stop.
5. Push "LEFT" & "RIGHT" button together. Front will raise to previous drop off height. Push "FRONT"
button if more height is needed.
6.
Back tow vehicle to align 5th wheel hitch.
7. Push the scroll arrow to display "AUTO RETRACT ALL."
8.
Push "ENTER." Landing Gear jacks will automatically retract and then stop.
9.
Raise inner drop legs on all jacks and secure with quick release pull pin.
10. Turn "ON/OFF" button off.

Truck Hauler Operation (Manual ONLY)

1.
Loosen J.T. Strong Arm Stabilizer "T" handles (if applicable).
2. Turn the Touch Panel "ON." LED lights up green.
3.
Push "FRONT" button to extend FRONT jacks to gain height.
4.
To retract jacks:
A. Push "RETRACT" button; Orange LED lights up (Fig. 4).
B. Push the "FRONT" button to retract jacks and hook up vehicle.
Once 5th wheel is coupled, push "FRONT" button and hold until
jacks are fully retracted.
C. Push "ON/OFF" button to turn system off. Green light will go out.
D. Double check 5th wheel latch is secure and that all jacks are
retracted.
E.
Ready to tow.
Rev:11.08.19
Fig. 3
A
Page 13
C
B
Fig. 4
CCD-0001573-08