Smart Jack; Introduction; Safety Requirements; Preparation - Lippert Components Ground Control 2.0 Master Owner's Manual

Introduction

The Aftermarket Smart Jack features a high-efficiency motor, a new streamlined plastic shroud, and a new
user interface. These features, along with the single power lead and the hitch height memory, give the end
user a perfect reason to replace the traditional tongue jack with a far superior product.

Safety Requirements

Warning, Caution and Danger symbols indicate that an installation procedure has a safety risk involved and
may cause death, serious injury or property damage if not performed safely and within the parameters set
forth in this manual. Always wear eye protection when performing this installation procedure. Other safety
equipment to consider would be hearing protection, gloves, and possibly a full face shield, depending on
the nature of the installation procedure.
Failure to act in accordance with the following may result in death, serious injury or property
Lifting the unit off of the ground so that the unit's wheels are not touching the ground will create an
unstable and unsafe condition. Severe property damage, serious injury or death could occur. Keep
people and pets clear of the unit and work area while operating the leveling system.

Preparation

Be sure to park the unit on solid, level ground. Clear all jack landing locations of debris and obstructions.
Locations should also be free of depressions. When parking the unit on extremely soft surfaces, utilize load
distribution pads under each jack. Make sure tires are chocked.
Rev: 11.08.19

SMART JACK™

LEVELING AND STABILIZATION
Moving parts can pinch, crush or cut. Keep clear at all times.
damage.
Page 131
CCD-0001573-08