Lippert Components Ground Control 2.0 Master Owner's Manual page 21

Top of Jack Motor Override:
3/8
Tools needed:
" drive ratchet and extension (no socket)
1.
Find the port on the top of the jack motor (Fig. 6A).
2.
Remove the rubber plug (Fig. 7A).
3/8
3. Insert the " drive into the port (Fig. 8).
4.
Turn override until the jack extends or retracts to desired position.
Fig. 6
A
Bottom of Jack Motor Override:
3/8
Tools needed:
" drive ratchet and extension,
1. Find the port on the bottom of the jack motor (Fig. 9A).
2.
Remove the rubber plug (Fig. 10A).
3.
Insert the 5/16" socket into the port (Fig. 11).
4.
Turn override until the jack extends or retracts to desired position.
Fig. 9
A
Rev:11.08.19
Fig. 7
A
5/16
" socket
Fig. 10
A
Page 21
Fig. 8
Fig. 11
CCD-0001573-08