Swing Down Stabilizer; Introduction; Safety - Lippert Components Ground Control 2.0 Master Owner's Manual

Introduction

The Swing Down Stabilizer was designed to be an easy-to-install, easy-to-operate stabilizer for lightweight
travel trailers. The leg extends a full 6". The Swing Down Stabilizer is infinitely adjustable from its retracted
and extended length, which minimizes time and effort to support the trailer. Rectangular, steel tubing gives
a support leg with high strength and minimal weight. A 4-inch square steel foot pad completes the sturdy
assembly.

Safety

Read and fully understand all instructions before installing or operating this product. Adhere to all safety labels.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause
death or serious personal injury if not performed safely and within the parameters set forth in this
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Trailer MUST be supported per manufacturer's recommendations before working underneath.
Never exceed the rated trailer capacity, trailer can collapse or tip over.
Soft or spongy areas may allow stabilizer to sink, causing trailer to tip over. Additional support may be necessary.
Do not place blocks under the stabilizer foot for additional ground clearance.
Put the Swing Down Stabilizer in a stored position before moving trailer.
Rev: 11.08.19

SWING DOWN STABILIZER

LEVELING AND STABILIZATION
Failure to do so may result in death or serious personal injury.
Moving parts can pinch, crush or cut. Keep clear and use caution.
manual.
Page 162
CCD-0001573-08