Troubleshooting; Error Display In Lcd Screen - Lippert Components Ground Control 2.0 Master Owner's Manual

Troubleshooting

Error Display In LCD Screen

To clear an Error Code, repair, correct the issue or press ENTER button (Fig. 1C). If the error remains, the error
message will reappear.
LCD Message
Controller not properly secured.
"EXCESS ANGLE"
Excessive angle reached during auto operation.
Controller not properly secured.
"EXCESSIVE ANGLE"
Excessive angle reached during manual operation.
Front of 5th Wheel below level when starting auto-level
process (only when trying to initiate Hitch Recognition).
"FEATURE DISABLED"
Touchpad power not cycled between consecutive
leveling operations.
Zero Point not set.
"LOW VOLTAGE" Battery voltage dropped below 9.5V.
Jack has reached maximum stroke length and is
"OUT OF STROKE"
unable to lift.
Bad connection or wiring from the controller to
"EXTERNAL SENSOR"
the sensor.
"JACK TIME OUT" Time limit exceeded for the requested auto operation.
Unable to auto-level due uneven ground.
"AUTO LEVEL FAIL"
Unable to auto-level due to Zero Point being
set incorrectly.
"BAD CALIBRATION"
Sensor calibration values are out of range.
"INTERNAL SENSOR"
Internal sensor problem.
**PANIC STOP** The User pressed a button on the touchpad during an
automatic operation.
"FUNCTION ABORTED"
Rev:11.08.19
What's Happening?
Error Codes
What Should Be Done?
Check and secure controller placement.
Relocate the 5th Wheel.
Check and secure controller placement.
Relocate the 5th Wheel.
Push the FRONT Button to raise the 5th Wheel up to hitch
height and connect to tow vehicle.
Turn touchpad off and then back on to reset the system.
Set Zero Point.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Check disposition of jacks and/or relocate the 5th Wheel.
Replace or repair connection to rear remote sensor.
Check disposition of jacks.
Check disposition of jacks and/or relocate the 5th Wheel.
Reset zero point.
Replace controller.
Replace controller.
Restart automatic operation and then refrain from
pressing any buttons on the touchpad.
Page 150
CCD-0001573-08