Class C Hydraulic Leveling; System Information; Component Description; Safety Information - Lippert Components Ground Control 2.0 Master Owner's Manual

System Information

Please read and study the operating manual before operating the leveling system. The Class C Hydraulic Leveling
System is an electric/hydraulic system. A 12V DC electric motor drives a hydraulic pump that moves fluid
through a system of hoses, fittings and jacks to level and stabilize the coach. Mechanical portions of the Class C
Hydraulic Leveling System are replaceable. Contact Lippert Components, Inc. to obtain replacement parts.

Component Description

1.
Jacks
A. Steel jack rated at a lifting capacity for the coach.
B. 9" diameter (63.5 square inch) footpad on a ball swivel for maximum surface contact on all
surfaces.
C. 12" diameter - (113 square inch) footpad also available.
D. Powered from a 12V DC motor/pump assembly.
2.
Motor/Pump Assembly
A. 12V DC motor
B. Hydraulic fluid reservoir tank
C. Control valve manifold
D. Solenoid valves
3.
System Controls
A. Controlled electronically from touchpad.
B. Touchpad can be operated in manual mode or fully automatic mode.
4.
Fittings and Hoses
A. Fittings - High pressure O-Ring Face - Size 4
B. Hose - 1/4" I.D., 3000 psi - W.P. Rated

Safety Information

Make sure that the coach is supported at all four corners according to the manufacturer's
recommendations. Lift the coach by the frame and never the axle or suspension. Do not go under
the coach unless it is properly supported. Unsupported coaches can fall causing death, serious
personal injury, severe product or property damage or voiding of the component warranty.
Failure to act in accordance with the following may result in serious personal injury or death.
The use of the Lippert Components, Inc. Class C Hydraulic Leveling System to support the coach for any reason
other than which it is intended is prohibited by the Lippert Limited Warranty. The Class C Hydraulic Leveling
System is designed as a leveling system only and should not be used to provide service for any reason under the
coach, e.g. changing tires or servicing the leveling system.
Lippert Components, Inc. recommends that a trained professional be employed to change the tires on the coach. Any
attempts to change tires or perform other service while coach is supported by the Class C Hydraulic Leveling System could
result in death, serious personal injury or severe product or property damage or voiding of the component warranty.
Rev: 11.08.19

CLASS C HYDRAULIC LEVELING

LEVELING AND STABILIZATION
Moving parts can pinch, crush, or cut. Keep clear at all times.
Page 115
CCD-0001573-08