Safety Information; Operation - Auto Leveling Control Touch Pad; Unhitching Instructions; Auto Level - Lippert Components Ground Control 2.0 Master Owner's Manual

Safety Information

Be sure to park the trailer on solid, level ground. Ensure all jack landing locations are cleared of debris and
obstructions and also free of depressions. People and pets should be clear of trailer while operating the
leveling system. Ensure the battery of the trailer is fully charged or that the trailer is plugged into shore
power prior to attempting to operate the system. Ground Control 3.0 requires a minimum of 12.75V DC from
the battery for proper operation.

Operation - Auto Leveling Control Touch Pad

Unhitching Instructions

NOTE: Prior to unhitching from the tow vehicle, ensure the trailer is parked on a level surface and chock the
tires of the trailer.
1. Extend the inner legs of both front jacks (landing gear) to within 4-5" of the ground by pulling on the
quick-release pins.
2.
To turn on the touch pad, press both "UP" and "DOWN" arrows (Fig. 1B and Fig. 1C) at the same time.
The green indicator LED (Fig. 1A) will turn on.
NOTE: The touch pad will remain on as long as the user is pressing buttons. It will time out after
approximately 7 minutes without use.
Press the "UP" arrow (Fig. 1B) to extend the front jacks and lift the front of the trailer to take the weight of
the trailer off of the hitch.
Uncouple the trailer connection on the tow vehicle.
Pull the tow vehicle away and park at a safe distance.

Auto Level

1.
After unhitching from the tow vehicle and parking the vehicle at a safe distance away from the trailer.
Press both "UP" and "DOWN" arrows (Fig. 1B and Fig. 1C) at the same time if the green indicator LED is not
on. Press "AUTO LEVEL" (Fig. 1D).
NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the leveling process is complete. Failure to remain still during the leveling cycle could
have an effect on the performance of the leveling system.

Auto Level Sequence

1. When Auto Level Sequence begins, the front of the trailer will seek a position near a level state.
2. Rear jacks will be grounded.
3. A side-to-side leveling sequence will occur.
NOTE: At this point on the 6 point system, the 2 middle jacks will be grounded to stabilize the trailer.
These 2 jacks do not level the trailer.
4.
Each jack will perform a final grounding touch.
NOTE: If the AUTO LEVEL sequence does not perform as described above, locate the OneControl Touch
Panel inside the trailer or use the OneControl App to place the system in manual mode. Test that
the jacks operate correctly by pushing their corresponding buttons on the OneControl Touch Panel
or app; e.g., "FRONT" button operates only the front jacks, etc. (See "Operation - OneControl Touch
Panel" or "Operation - OneControl App" in this manual).

Hitch Recognition

1. To turn on the touch pad, press both "UP" and "DOWN" arrows (Fig. 1B and Fig. 1C) at the same time.
The green indicator LED (Fig. 1A) will turn on.
2.
Press "HITCH HEIGHT" (Fig. 1E). The rear jacks will retract.
3.
The front of the trailer will raise to the height where the auto level sequence was started.
Rev:11.08.19
Page 26
CCD-0001573-08