Lippert Components PSX1 Motor Replacement

Stabilizer

Hide thumbs Also See for PSX1:

Download this manual

Purpose

This document outlines the removal and replacement of the PSX1 Stabilizer Motor.

Safety

The "CAUTION" symbol above is a sign that a safety risk is involved and may cause personal injury

and/or product or property damage if not safely adhered to and within the parameters set forth

Always wear eye protection when performing this installation procedure. Other safety

equipment to consider would be gloves and possibly a full face shield, depending on the

Resources

• 4 mm hex wrench

• 8 mm combination wrench

• Rotary cutting/grinding tool

Procedure

Motor Removal

Disconnect power to the motor from the power source of the unit.

Using the 8 mm combination wrench and 4 mm hex wrench, remove the two socket cap screws and

nuts securing one side of the motor to the motor mounting plate.

Using the 4 mm hex wrench only, remove the remaining two socket cap screws securing the motor to

the motor mounting plate.

NOTe: Motor mounting plate not

shown for clarity.

Rev: 02.01.21

PSX1™ STABILIZER MOTOR REPLACEMENT

LEVELING AND STABILIZATION

nature of the installation procedure.

Socket Cap Screw

in this manual.

Fig. 1

Page 1

Nut

CCD-0004129

Page 1 PSX1™ STABILIZER MOTOR REPLACEMENT LEVELING AND STABILIZATION Purpose This document outlines the removal and replacement of the PSX1 Stabilizer Motor. Safety The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury and/or product or property damage if not safely adhered to and within the parameters set forth in this manual.
Page 2 PSX1™ STABILIZER MOTOR REPLACEMENT LEVELING AND STABILIZATION Motor Replacement Line up the motor shaft (Fig. 3) on the new motor with the coupler (Fig 2) and install the new motor using the previously removed socket cap screws and nuts. NOTe: When installing the new motor, it may be necessary to enlarge the bracket hole from 0.97" to 1.18"...