Touch Pad Error Codes - Lippert Components Ground Control 2.0 Master Owner's Manual

Touch Pad Error Codes

NOTE: To clear an error code from the touch pad, repair or otherwise correct the issue, then press "ENTER." If
the error is still present, the message will be displayed again.
LCD Message
****ERROR****
Excess Angle
****ERROR****
Excessive Angle
****ERROR****
Feature Disabled
****ERROR****
Low Voltage
****ERROR****
Out Of Stroke
****ERROR****
External Sensor
****ERROR****
Jack Time Out
****ERROR****
Auto Level Fail
****ERROR****
Comm Error
****ERROR****
Bad Calibration
****ERROR****
Internal Sensor
**PANIC STOP**
Function Aborted
****ERROR****
Hall Effect Short
Rev:11.08.19
What's Happening?
Controller not properly secured.
Excessive angle reached during
auto operation.
Controller not properly secured.
Excessive angle reached during
auto operation.
Front of trailer below level when
starting Auto Level process (only
when trying to initiate Hitch
Recognition).
Touch pad power not cycled
between consecutive leveling
operations.
Zero point not set.
Battery voltage dropped below
10.8V.
Jack has reached maximum stroke
length and is unable to lift.
Unexpected high amp current stall.
Bad connection or wiring from the
controller to the rear sensor.
Time limit exceeded for the
requested auto operation.
Unable to auto level due to uneven
ground.
Unable to auto level due to zero
point being set incorrectly.
Communication between controller
and touch pad has been lost.
Sensor calibration values are out of
range.
Internal sensor problem.
The user pressed a button on the
touch pad during an automatic
operation.
Short circuit detected in one of the
hall effect circuits.
What Should Be Done?
Check and secure controller placement.
Relocate the trailer.
Check and secure controller placement.
Relocate the trailer.
Using manual mode on the touch pad, retract rear
(which includes the middle, if equipped) jacks and
set landing gear (front jacks) to hitch height.
Turn touch pad off and then back on to reset the
system.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load - charge or replace.
Check disposition of jacks. Relocate the trailer.
Check jacks in manual mode or perform manual
override procedure. Repair or replace as needed.
Check for bent or damaged jacks. Repair or replace
as needed.
Replace or repair connection to rear remote sensor.
Check disposition of jacks.
Check disposition of jacks. Relocate the trailer.
Reset zero point.
Check harness for proper connections or damage.
Replace if necessary.
Replace controller
Replace controller
Restart automatic operation and then refrain from
pressing any buttons on the touch pad.
Test for short and repair or replace.
Page 22
CCD-0001573-08