Wiring Diagram; Relay Control Module - Lippert Components Happijac Installation Manual

7.
Place the switch over the hole, and secure it with the screws provided. Make sure the switch is
positioned such that both screws will securely hold the switch in place (Fig. 13).

Wiring Diagram

Relay Control Module

RVIA wiring requirements restrict the length of exposed motor leads to a maximum of 10". Therefore,
the Relay Control Module must be placed above the motor or on the wall of the vehicle in close enough
proximity to the motor that the 10" motor lead will reach.
To
Motor
RELAY CONTROL MODULE
3-pin
To Upper
Limit Switch
Rev: 07.03.18
A
To
Brake
(Top View)
2-pin
To Lower
Limit Switch
Fig. 13
B
Fig. 14
All outputs are marked on the underside of the module.
RJ-11 Communication
Cable
NOTE: RJ-11 cable must be straight
Page 7
Power Pigtail
supplied with Relay
Control Module
Butt
Connectors
}
+12V DC
10 AWG
from power
source
Ground
through cable — standard
telephone cable will not work.
CCD-0001541