Operation; Zero Point Calibration; Basic Landing Gear Operation - Lippert Components Level-Up Owner's Manual

Operation

Use the LCD touchpad (Fig. 1) to operate the Level-Up hydraulic system.
E
A
D
B
C
Callout Description
A Up Arrow - Scrolls up through the menu on LCD.
B Down Arrow - Scrolls down through the menu on LCD.
C ENTER - Activates modes and procedures indicated on LCD.
D RETRACT - Places leveling system into retract mode while in manual mode only.
E LCD Display - Displays procedures and results.
F AUTO LEVEL - Places leveling system into auto level mode.
G FRONT Button - Activates both front jacks.
H LEFT Button - Activates left leveling jack(s) in manual mode.
I RIGHT Button - Activates right leveling jack(s) in manual mode.
J REAR Button - Activates leveling jacks in manual mode.
K Power Button (ON/OFF) - Turns leveling system on and off.

Zero Point Calibration

The "Zero Point" is the programmed point in which the 5th Wheel will return to whenever the auto-level
feature is used. The Zero Point is preset at the factory.

Basic Landing Gear Operation

1.
Landing Gear Jacks
A. Landing gear jacks can be operated any time the system is on, but NOT in AUTO MODE. Press the
FRONT Button (Fig. 1G), so that both the front, or landing gear, jacks can be extended.
B. If the touchpad is put in the RETRACT mode, indicated by the illuminated LED next to its button
(Fig. 1D), the front jacks can be retracted together by pressing the FRONT Button.
Rev: 02.14.19
Gray
G
H
F
LEDs
LCD Touchpad Features
Fig. 1
A
K
B
C
I
J
Page 5
Black
E
G
H
D
F
LEDs
K
I
J
CCD - 0001531