System Description; Operation; Preparation - Lippert Components Ground Control 2.0 Master Owner's Manual

System Description

Please read and study the Operation section of the manual before operating the PSX2™. The PSX2™ is a 12V
DC electric motor-driven system. The electric motors drive Acme-threaded screws to extend and retract the
stabilizer legs to stabilize the trailer.
The stabilizing system can be installed on travel trailers and 5th Wheels. Travel trailer options include both
front and rear stabilizers or a rear stabilizer only, while 5th Wheels typically utilize only a rear stabilizer. The
PSX2™ has two motors per stabilizer.
There are no serviceable parts within the electric motors. If either motor fails, it must be replaced.
Disassembly of the motor voids the warranty. Mechanical portions of the PSX2™ are replaceable. Contact
Lippert Components, Inc. to obtain replacement parts.

Operation

Failure to act in accordance with the following may result in death or serious injury. Always make sure that
the stabilizer area is clear of people, pets and objects before and during operation of the system. Always
The PSX2™ is to be used for stabilizing the trailer, not leveling the trailer. The stabilizer legs should never be
extended longer than two seconds beyond initial contact with the ground.

Preparation

The PSX2™ is intended for the purpose of stabilizing the trailer after the trailer has been leveled.
Never lift the trailer completely off the ground. Lifting the trailer completely off the ground creates an
unstable condition that could result in death, serioius personal injury or severe product or property damage.
1. Make sure the trailer is parked on solid, level ground.
2.
Clear all stabilizer leg landing locations of debris and obstructions. Locations should be free of
depressions.
3.
When parking the trailer on extremely soft surfaces, utilize load distribution pads under each stabilizer
leg.
4.
Make sure people and pets are clear of the trailer while operating the stabilizers.
Rev:11.08.19
keep away from the stabilizer legs when operated.
Moving parts can pinch, crush or cut. Keep clear and use caution.
Page 110
CCD-0001573-08