Table of Contents
Advertisement
Table 10-1 Error Messages from the Software RAID1 construction utility (2/2)
No.
Error message
7
Disk is not mounted.
8
Disk access error on
HDD#X.
9
RAID condition is not
correct.
10
Cannot execute the Prepare
For Restore operation.
Description
Rebuild or a consistency check is
selected when two HDDs are not
mounted.
Access to the RAID1 configuration
information of the HDD#X (X is an
HDD number) failed.
The configuration or status of the array
is not normal.
The backup restoration preparation
function cannon be executed.
10-35
10. SOFTWARE RAID1
Corrective action
Make sure two HDDs are mounted, and then start
rebuild or a consistency check.
Replace the failed HDD, and then start rebuild.
Set the status of the software RAID1 to be normal
(that is, Array Status on the status display for
RAID1 is "OPTIMAL" or "OPTIMAL (MEDIA
ERROR)"), and then start a consistency check.
Check the status of installation of the HDDs.
Make sure both HDDs are installed, and then start
the backup restoration preparation function.
Advertisement
Table of Contents
