Replacing Lithium Battery; Figure 5-15 Replacing Lithium Battery - Hitachi HF-W2000 35 User Manual

5.5.2 Replacing lithium battery

1. Unmount the cover of the Equipment according to the procedure in "(1) (a)
Unmounting the cover of the Equipment" in Subsection 5.4.1.3, "Inserting/extracting
extended board on HJ-2035." This procedure also applies to unmounting the cover of
the Equipment on HJ-2030.
2. Referring to Figure 5-15 below, unload the lithium battery from the battery holder.
3. Disconnect the BAT cable connectors of the unloaded lithium battery from the mating
connector terminals on the motherboard.
4. Connect the BAT cable connectors of a new lithium battery to the mating connector
terminals on the motherboard.
5. Load the new lithium battery into the battery holder by reversing step 2.
6. Remount the cover of the Equipment by reversing the procedure referenced in step 1.
Lithium battery
+
First pull up the
upper lid of the
battery holder.

Figure 5-15 Replacing Lithium Battery

5-27
5. INSPECTION AND MAINTENANCE
–
Battery holder
BAT connector
Then pull down
the lower lid of
the battery holder.