(2) Exiting the utility
Follow the procedure below to exit the software RAID1 construction utility.
1. On the menu screen, enter "5" and then press the [Enter] key.
Select Function :
1:Status
2:Rebuild
3:Consistency Check
4:Prepare For Restore
5:Quit
Please select No.= 5 (Enter)
2. The following message is displayed and then the utility finishes.
Software RAID1 Construction Utility is finished.
3. Remove the software RAID1 construction utility "Software RAID1 For Windows(R)"
from the DVD drive. Then press the power switch for four seconds or more to shut down
the power for the Equipment.
If you disconnected any external storage devices before you start the software RAID1
construction utility, reconnect them to the Equipment.
10-25
10. SOFTWARE RAID1