Hardware Connection - Hitachi HF-W2000 35 User Manual

1.3

Hardware Connection

 Be sure to route power cords away from interface cables, as well as from
power cords and interface cables of any third-party devices such as PCs.
Otherwise, a machine failure or malfunction may result.
 Before connecting or disconnecting an interface cable, shut down the OS
both on the Equipment and on the target device, as well as disconnect both
the Equipment power supply cord from the outlet and the power supply cord
of the target device from the outlet. Otherwise, a machine failure due to a
short circuit may result.
 If an interface cable gets disconnected while the Equipment is powered, first
shut down the OS and then disconnect the Equipment power supply cord
from the outlet. Sudden power disconnection without shutting down the OS
may corrupt file.
 If there is a cable for external contact point, ensure that it is connected to the
EXT (external control). Because a maximum voltage of 40 V dc may be
applied to this cable through the relay load, erroneous connection of this
cable to a wrong connector may cause a failure.
< NOTE >
 Procure a power cord with a 2-pole 3-wire plug with ground for the Equipment as
defined in Section 1.4, "Power supply cord". Fully insert the plug of the procured
power cord into a suitable AC mains power outlet as illustrated in Figure 1-5.
 The Equipment ships with an optional cable clamp to fix the power cord to the chassis.
Attach this cable clamp on an as necessary basis.
After connecting the display unit, the keyboard, and the mouse to the Equipment, insert the
power cord plug into the outlet as illustrated in Figure 1-5. For cable lengths, see
Section 4.9, "Miscellaneous Requirements".
NOTICE
1-7
1. GETTING STARTED