Table of Contents
Advertisement
Pay attention not to apply shock to the replacing HDD and the replaced HDD
during work, whether installed or not installed on the Equipment. When not
installed, place each HDD on a shock-absorbing material such as antistatic
cushion, even temporarily. Direct placement on a hard surface such as desktop
may cause damage, data corruption, or shortening of service life due to shock.
Insert the HDD firmly and precisely. A loose contact or a missing screw will
cause a failure.
While the HDD is powered, never attempt to unscrew and hot-plug the HDD.
Otherwise, a machine failure or HDD failure may result.
The HDD detachment/attachment must be limited to the least, e.g., replacement
in the event of a failure. Frequent detachment/attachment may cause damage to
the Equipment.
On D Model, also observe the following:
Do not altogether replace the two HDDs in RAID1 configuration.
Since each D Model has its own RAID1 configuration information (e.g.,
serial number), you cannot swap HDDs even between D Models. If you dare,
the stored data in the newly installed HDD will be erased with automatic
RAID1 rebuilding process due to inconsistency of the RAID1 configuration
information. If you own multiple D Models, manage use and inventory of
HDDs so that they are not inadvertently mixed.
Never remove the HDD if the corresponding HDD status lamp is off.
Otherwise, the stored data will be destroyed.
When you replace an HDD while the Equipment power is on, first stop the
power supply to the target HDD by placing the HDD into OFFLINE state in
the "Hardware status" window. Never attempt HDD replacement before this
window is ready (e.g., immediately after the OS startup). Otherwise, a
machine failure or HDD failure may result.
When you intend to move the Equipment, first shut down the OS, then
disconnect the power cord plug from the outlet, and wait at least one minute.
Otherwise, failure of hardware such as HDD may result.
When transporting or carrying the Equipment, repack it using the packing
materials that came with it and are not broken or dented. Transporting or
carrying the Equipment either packed by other packing materials or repacked by
broken or dented packing materials may damage the Equipment.
By the characteristics of rush current suppression circuit on this Equipment, a
larger rush current than usual may flow when power is supplied before the
power supply unit is naturally cooled after the last power-off. To avoid possible
adverse effects on the connected electronic devices such as fuse-free breakers
and on the service life of this Equipment, wait at least one minute of the last
power-off before you supply power to the Equipment.
SAFETY SUMMARY (Continued)
S-10
(See Section 8.2 on page 8-2.)
Advertisement
Table of Contents
