Table of Contents
Advertisement
244 Driving mode
Setting PPC (Predictive Powertrain Control)
To activate/deactivate: activate or deacti‐
#
vate PPC in the multimedia system under the
Controls
menu and the Settings,
systems
menu item.
To set the speed tolerances/factors: press
#
the Z button on the multifunction steer‐
ing wheel repeatedly until the
input window is displayed in the instrument
cluster.
Change back and forth between the setting
#
options by swiping up or down using the mid‐
dle steering-wheel button on the left-hand
control panel.
Set the speed tolerances/speed factors by
#
swiping right or left using the middle steering-
wheel button on the left-hand control panel.
Setting the upper speed tolerance
Select menu item
1
to set the upper speed
#
tolerance.
The speed tolerance changes in 1 km/h
increments from 2 km/h to 15 km/h.
The standard value for the upper speed toler‐
ance is 2 km/h.
The higher you set the upper speed tolerance, the
greater the savings in fuel.
If cruise control is activated and the set speed is
50 km/h or less, the upper speed tolerance is
specified at 2 km/h.
Setting the speed tolerance when driving
down depressions in the road
Select menu item
2
to set the speed toler‐
#
ance when driving down depressions in the
road.
The speed tolerance changes in 1 km/h
increments from 0 km/h to 4 km/h.
The standard value for the downhill speed tol‐
erance is 0 km/h.
The higher you set the downhill speed tolerance,
the greater the savings in fuel.
If cruise control is activated and the set speed is
50 km/h or less, the downhill speed tolerance is
specified at 0 km/h.
Setting the lower speed tolerance
Select menu item
#
tolerance.
The speed tolerance changes in five levels.
Level two is set as standard.
The higher you set the lower speed tolerance, the
greater the savings in fuel.
Assistance
Setting the cornering speed factor
Select menu item
#
speed factor.
The speed factor changes in five levels.
Cruise control
Level three is set as standard.
The higher the level set, the higher the vehicle
speed when cornering.
Setting the start of deceleration before route
events
Select menu item
#
eration.
The start of deceleration changes in five lev‐
els.
Level three is set as standard.
The higher the level is set, the earlier the vehicle
starts deceleration before a route event.
Resetting the settings
Select menu item
#
to the default values.
Active Brake Assist
Overview of Active Brake Assist
General notes
The term used in following sections, Active Brake
Assist, also applies to Active Brake Assist 5.
Deactivate Active Brake Assist when towing.
For vehicles operated in Ukraine: also observe
the information on "Radar sensor system radio
type approval" (
If Active Brake Assist detects the risk of a colli‐
sion with the vehicle in front, it issues an audible
and visual warning. If you do not react and the
risk persists, Active Brake Assist automatically
3
to set the lower speed
4
to set the cornering
5
to set the start of decel‐
6
to reset all the settings
page 12).
/
Advertisement
Table of Contents
