Table of Contents
Advertisement
52
Opening and closing
described for the blackout screen 2, and
allow it to hang in the cab.
Where necessary, press the screens against
#
the roof frame and insert the hexagon socket
wrench
5
into the actuator motor through
the opening 4.
Turn the hexagon socket wrench
#
wise until the sliding sunroof is completely
closed.
Insert the guide bar
1
#
screen
3
into the screen guides in the roof
frame, turn it so that it is parallel to the end
position and guide the screen back into the
end position.
Insert the guide bar for the blackout screen
#
2
into the screen guides in the roof frame,
turn it so that it is parallel to the end position
and guide the blackout screen
the end position.
Resetting the sliding sunroof
Reset the sliding sunroof after a voltage supply
interruption or when it has been opened with a
jerk.
Press and hold the P button until the slid‐
#
ing sunroof has been completely closed for
three seconds.
Closing the pop-up roof mechanically
%
The flathead screwdriver (blade width: 4 mm)
can be found in the vehicle tool kit.
Vehicles with a ClassicSpace cab
#
#
#
5
clock‐
Vehicles with a Big-/Stream-/GigaSpace cab
#
for the insect roller
2
back into
#
Remove the cover cap from the opening 1.
Insert the flathead screwdriver
actuator motor through the opening
turn it anti-clockwise until the pop-up roof is
completely closed.
Insert the cover cap into the opening 1.
Remove the cover from the roof lining
Insert the flathead screwdriver
actuator motor through the opening
turn it anti-clockwise until the pop-up roof is
completely closed.
2
into the
1
and
4
into the
3
and
Advertisement
Table of Contents
