Table of Contents
Advertisement
262 Driving mode
5
Buttons
u To activate the control panel, make a pre‐
selection for the front axle, rear axle, entire
vehicle or driving level
t To activate the control panel, make a pre‐
selection for the front axle, rear axle, entire
vehicle or driving level
r To activate the control panel, lower the
chassis, set the driving level
s To activate the control panel, raise the
chassis, set the driving level
To activate the control panel, end raising or
T
lowering operation
û Press button briefly: to call up memory
position M1 or M2 for chassis height
Press and hold button: to store memory
position M1 or M2 for chassis height
Apply the parking brake.
#
Switch on the ignition.
#
The level control automatically adjusts the
chassis frame to the previously stored height.
If the reservoir pressure in the compressed-
#
air system is too low, leave the engine run‐
ning.
The compressed-air system is charged.
Take the control panel out of the holder.
#
Activating the control panel
Control panel on the outside of the driver's
#
seat: briefly press the u, t, r,
s or T button.
or
External control panel on the vehicle body:
#
press the T button for approximately two
seconds.
%
The external control panel on the vehicle
body can be activated and deactivated even
if the key has been removed.
Deactivating the control panel
External control panel on the vehicle body:
#
press the T button again for approximately
two seconds.
or
External control panel on the vehicle body
#
and on the outside of the driver's seat: wait
approximately 60 seconds; do not press a
button.
or
Drive at a speed above approximately
#
30 km/h.
The control panel is automatically deactiva‐
ted.
Raising or lowering the chassis with the con‐
trol panel
& WARNING Risk of entrapment from vehi‐
cle lowering
When lowering the vehicle, other people
could become trapped if their limbs are
between the vehicle body and the tyres or
underneath the vehicle.
Make sure no one is underneath the
#
vehicle or in the immediate vicinity of
the wheel arches when the vehicle is
being lowered.
Press the u or t button to select front
#
axle 1, entire vehicle
2
The LEDs for the selected preselection light
up.
Press the r button to lower the chassis or
#
the s button to raise it.
If the chassis is not at driving level, the ¸
indicator lamp in the instrument cluster lights
up. In addition, the on-board computer shows
a yellow event window with = or ?
and
Set driving
level..
Press the T button to interrupt/end the rais‐
#
ing or lowering operation.
Storing/calling up the chassis height
Select the
Level control
#
multimedia system under the
Storing
Raise/lower the chassis to the desired
#
height.
Press the û button on the multimedia sys‐
#
tem for approximately two seconds for mem‐
ory preset M1 or M2.
The current chassis height is stored under the
corresponding û button.
Calling up
Briefly press the û button for memory
#
position M1 or M2.
The chassis will be raised/lowered automati‐
cally to the stored height. The instrument
or rear axle 4.
menu item in the
Controls
menu.
Advertisement
Table of Contents
