When you are pulling out the sitting surface,
make sure that no one has any body parts
within the sweep of the sitting surface.
The safety net on the top berth is not a restraint
system to enable the berth to be used while the
vehicle is in motion.
The seat/berth combination is not suitable for
child restraint systems. Never fit a child restraint
system anywhere other than the front passenger
seat. Observe the safety notes in the "Children in
the vehicle" section (
page 38).
/
There is a sitting position and a berth position for
the seat backrests and/or sitting surfaces.
Folding the top berth upwards/downwards
Folding the seat backrest up into the berth
position
Detach retaining straps
#
right of the seat backrest 2.
#
#
#
Folding the seat backrest down into the seat
position
#
#
#
#
Pulling out/pushing in the bottom berth
#
#
#
1
on the left and
Driver cockpit
Swing seat backrest
2
upwards.
Swing seat backrest
2
into the horizontal
position and hold it in place.
Clip seat belt tongues
4
into the right and
left seat belt buckles 3.
Lift seat backrest
2
slightly, hold it in place
and press release buttons
5
buckles
3
on the left and right.
Swing seat backrest
2
upwards slightly.
Swing the berth down until it reaches the rear
panel.
Clip retaining straps
1
to the left and right
of the seat backrest 2.
Pulling the sitting surface out into the
berth position: Use loop
3
ting surface up and forwards.
Hook holders
2
into detents 1.
Pushing the sitting surface into the seat
position: Use loop
3
to lift the sitting sur‐
face and push it back.
63
for seat belt
to pull the sit‐