Table of Contents
Advertisement
PPC on/off
R
EcoRoll on/off
R
If a driver does not insert their driver card into
the tachograph for more than four hours or the
ignition has been switched off for that period, in
some cases the settings are reset to minimum
values (see the following table).
This is most likely to happen when the settings
selected by the driver have a negative impact on
the fuel consumption. If the driver has selected
settings which are more economical than the
minimum value for fuel consumption in the fol‐
lowing table, then the settings will be maintained.
Stored settings:
Setting
Reset value for
extended absence
Selected drive pro‐
Aeconomy/Aeconomy
gram
+
EcoRoll on/off
EcoRoll on
PPC on/off
PPC on
PPC Interurban
PPC Interurban on
on/off
Upper speed toler‐
2 km/h (enquiry via
ance
pop-up)
Downhill speed toler‐
0 km/h (enquiry via
ance
pop-up)
Lower speed toler‐
4 km/h, if lower value
ance
is set
Cornering speed fac‐
Level 3, if higher value
tor
is set
Start of deceleration
Level 3, if lower value
before route events
is set
1 For the Fire and Fleet drive
programs the reset values are
Fire or Fleet.
Note on the "Upper speed tolerance" and "Down‐
hill speed tolerance" settings: if the value set by
the driver is different from the reset value, the
value currently set is shown when the engine is
started (pop-up) and can be confirmed by the
driver.
If the driver does not confirm the value settings
shown then the default values are restored auto‐
matically.
System settings
Display
Configuring display settings
Requirements:
R
Multimedia system:
4
5
Styles
#
Display brightness
#
#
Switching the display off/on
1
#
#
Activating/deactivating the assistance view
of Distance Assist DISTRONIC
#
#
Time and date
Automatically setting the date and time
Requirements:
R
%
Multimedia system:
4
5
#
Multimedia system 161
The vehicle is standing still.
©
Operation
Settings
5
5
Display & operation
Select
Classic
or
Advanced
tion with a multimedia system).
Select
Display
brightness.
Select a brightness value.
To switch off: select
Display
To switch on: select a menu on the operating
strip.
To deactivate: switch off
Assistance view
during distance control
E.
To activate: switch on
Assistance view dur-
ing distance control
D.
If a tachograph or a GPS device is availa‐
ble:
Manual time adjustment
as an option.
If a tachograph or a GPS device is available in
the vehicle, you can only change the time
zones. The time and date are set automati‐
cally when your vehicle is equipped with a
tachograph of GPS device.
©
Operation
Settings
5
5
Display & operation
Time and date
5
Deactivate
Manual time adjustment
The time and date are set automatically for
the selected time zone and summer time
option.
(only in combina‐
off.
is not available
E.
Advertisement
Table of Contents
