Table of Contents
Advertisement
The first phase is the instrument cluster display
check. The indicator lamp will light up for approx‐
imately five seconds and then go out for approx‐
imately ten seconds.
The second phase indicates the system check
status. The indicator lamp will either light up
again for five seconds or flash for approximately
five seconds. It will then go out for five seconds.
In the third phase, the indicator lamp will indicate
whether any emissions-related malfunctions have
been detected.
If no emissions-related malfunctions are detec‐
ted, the indicator lamp will light up briefly and
then go out for approximately five seconds. This
flashing sequence will be repeated until the
engine is started.
If an emissions-related malfunction is detected,
the indicator lamp will flash three times and then
go out for approximately five seconds. This flash‐
ing sequence will be repeated until the engine is
started. The indicator lamp will remain lit for
approximately 15 seconds after the engine is
started.
In the following cases, the indicator lamp will
light up and remain lit after the engine is started:
A serious emissions-related malfunction has
R
been detected.
An emissions-related malfunction was detec‐
R
ted more than 200 hours ago and is still pres‐
ent.
On-board computer
Notes/overview
& WARNING Risk of distraction from infor‐
mation systems and communications
equipment
If you operate information and communica‐
tion equipment integrated in the vehicle when
driving, you will be distracted from the traffic
situation. This could also cause you to lose
control of the vehicle.
Only operate this equipment when the
#
traffic situation permits.
If you cannot be sure of this, stop the
#
vehicle whilst paying attention to road
and traffic conditions and operate the
equipment with the vehicle stationary.
On-board computer and displays 123
You must observe the legal requirements for the
country in which you are currently driving when
operating the on-board computer.
On-board computer (example)
1
Instrument cluster
2
Navigates/confirms/selects on the on-board
computer
¤ Main menu and back button
You can operate the on-board computer via the
left-hand button group on the multifunction steer‐
ing wheel.
The on-board computer will provide you with
information when you are driving, such as the fol‐
lowing:
Fuel consumption
R
Trip time
R
Operating statuses
R
Maintenance due dates
R
Malfunctions
R
Causes of malfunctions
R
Action to be taken
R
Advertisement
Table of Contents
