Table of Contents
Advertisement
Apply the parking brake.
#
Press the Æ button on the key.
#
Dipped-beam headlamps, marker lamps, tail
lamps and licence plate lighting light up per‐
manently. Turn signals, main-beam head‐
lamps, brake lights, daytime driving lights,
reversing lamps, foglamps and working-area
lamps are switched on one after the other.
This cycle is repeated three times.
If you want to cancel the lamp check, press the
Æ button again or release the parking brake.
Unlocking/locking the central locking system
External door lock
* NOTE Damage to the vehicle when open‐
ing the doors
Make sure that there is sufficient clearance
when opening the doors.
Otherwise, damage may be caused to the
vehicle or to other vehicles.
Only open doors if the situation permits
#
this.
Unlocking/locking using the key
%
If you use the emergency key element to
unlock the door and ATA is primed
(
page 45), the alarm is triggered.
/
Opening and closing
Insert the key into the door lock of driver's
#
door (Code F9Y only) d or of co-driver's
door e in position 2.
To unlock: turn the key to position 1. The
#
corresponding door is unlocked.
To lock: turn the key to position 3. Both
#
doors are locked.
Unlocking/locking using the remote control
To unlock: press the Ü button on the key.
#
The driver's door or both doors are unlocked.
%
You can change the unlocking function of the
remote control so that either both front doors
or just the driver's door is unlocked when you
press the Ü button. To switch between
the two unlocking functions, press and hold
both remote control buttons simultaneously
for approximately six seconds. The LED in the
key flashes twice as confirmation. If you have
selected the function that only unlocks the
driver's door, you can unlock the co-driver's
door by pressing the Ü button again.
To lock: press the ß button on the key.
#
Both doors are locked.
Internal door lock
Unlocking using the door handle
Pull the door handle.
#
43
Advertisement
Table of Contents
