Table of Contents
Advertisement
70
Driver cockpit
%
A fitted spring enables the camera arm to
automatically return to the correct operating
position in the event of minor deviations. In
the event of larger deviations, it may be nec‐
essary to manually return the camera arm to
the correct position.
The optical system of the camera is equipped
with a heating function which is automatically
activated/deactivated, depending on the temper‐
ature of the camera's sensor and the outside
temperature. This avoids the accumulation of
snow and ice in the area of the camera.
The heating can also be activated/deactivated
manually by pressing the Î button (see Oper‐
ation of the MirrorCam system (
%
Depending on the temperature signals it
receives, the automatic control system can
reverse manual activation/deactivation of
the heating.
Display (example: left-hand side of the vehicle)
The MirrorCam system display does not have a
separate heating function. The display does not
work at temperatures below -18° C (+/- 2° C)
(measured on the glass surface of the display).
At low temperatures, heat the vehicle interior
until the display starts working.
The display is divided in two by a status display
(blue line) 1.
The field of vision shown in upper section of
screen
2
corresponds to the main mirror; the
field of vision in bottom section
to the wide-angle mirror.
If status display
1
is not shown in the display,
there is a system error.
Operating the MirrorCam system
Automatic activation of the MirrorCam sys‐
tem
The system is automatically activated when the
following occurs:
Unlocking/opening the door
R
Unlocking/opening the vehicle
R
The ignition is switched on
R
%
Switching on the ignition results in perma‐
nent activation.
Manual activation of the MirrorCam system
Press the Ï button.
#
page 70)).
/
Within seven seconds of automatically or
manually activating the system, the field of
vision (basic setting) is available to the driver
in the display.
Door operating unit, driver's side
1
| Selects display, left
2
~ Selects display, right
3
Í Sets field of vision
4
Ï Activates/deactivates automatic field
of vision adjustment/manoeuvring view
5
Ï Manually activates system
6
Î Activates/deactivates camera heating
Control buttons 1, 2,
with indicator lamps, which indicate the status of
the function. The function is activated when the
indicator lamp in the button is lit.
3
corresponds
Standby mode and automatic deactivation
4
and
6
are equipped
Advertisement
Table of Contents
