Table of Contents
Advertisement
112 Climate control
Switching immediate heating mode on/off
Additional button on the bed/berth switch panel
(example: vehicle without stationary air condi‐
tioning system)
To switch on/off: press the y button
#
under the
Climate
controlmenu in the multi‐
media system (
/
page 108).
or
Press the ÷ button on the bed/berth
#
switch panel.
When the indicator lamps on the y and
÷ buttons light up, the auxiliary heating is
switched on.
Set the temperature, airflow, air distribution
#
and air vents according to your needs.
The automatic climate control will switch to
automatic mode automatically.
%
The blower can start up with a delay depend‐
ing on the coolant temperature.
The auxiliary heating will switch off automatically
after around eleven hours. The auxiliary heating
will continue to run for around two minutes after
it switches off.
%
In vehicles for the transport of hazardous
goods with engine preheating, engine pre‐
heating can be switched on only with imme‐
diate heating mode.
To switch on engine preheating: switch on
#
immediate heating mode.
Press the y button under the
#
control
menu in the multimedia system.
Engine preheating will switch off automati‐
cally with the auxiliary heating.
Setting the switch-on time
& DANGER Risk of fatal injuries if the vehi‐
cle is parked in unsuitable locations with
a pre-selected switch-on time for auxili‐
ary heating
If you have pre-selected a switch-on time, the
auxiliary heating will switch on automatically.
If sufficient ventilation is not assured, toxic
exhaust gases may build up, especially car‐
bon monoxide. That is the case in enclosed
spaces, for example.
If highly flammable substances or flammable
materials are nearby, there is a risk of fire and
explosion.
If the vehicle is parked in these or simi‐
#
lar conditions, always disable the pre-
selected switch-on times.
Switch-on times can be set for auxiliary heating
(warming the cab) and engine preheating (warm‐
ing the coolant). If the vehicle is equipped to
transport hazardous goods, no switch-on times
can be set.
In the multimedia system, select the
#
med times
trol
menu (
Select the
#
Set the desired values in the Time,
#
and
Temperature
In the
Function
#
the stationary heater or y and ü for
the stationary heater with engine preheating.
Press the & button.
#
A new air conditioning control will now have
been created.
The chosen settings can be seen on the but‐
ton of the corresponding air conditioning con‐
trol in the
To switch on/off: press the button of the
#
desired air conditioning control.
When the air conditioning control is switched
on, the indicator lamp on the button will light
up in red.
When the air conditioning control is switched
Climate
on, the yellow indicator lamp on the quick
access button ó below the multimedia
display will light up.
The selected climate control function will
switch on automatically at the switch-on
times set.
Program-
menu item from the
Climate con-
page 108).
/
New clim. ctrl setting
function.
Repeat
menu items.
menu item, select y for
Programmed times
menu.
Advertisement
Table of Contents
