Table of Contents
Advertisement
if the windscreen in the area of the camera is
R
obscured, e.g. due to a faulty windscreen
wiper or a sticker.
if the carriageway is very narrow and winding.
R
if detachable parts, e.g. a snow plough,
R
restrict the camera's view of the road lane
markings.
after a major change in load with the ignition
R
switched on. The engine should therefore be
started afresh after a major change in load so
that Adaptive Highbeam Assist is available
without restriction.
Keep the windscreen in the area of the camera
free of dirt, snow or ice. Use the windscreen wip‐
ers or clean the windscreen by hand if required.
Please note the sections "Notes on cleaning the
vehicle exterior" (
page 315) and "Cleaning
/
sensors" (
page 318).
/
If the system is malfunctioning, the high beam
will be switched off. The driver will be notified of
the malfunction by an event window displayed on
the instrument cluster.
If necessary, switch the high beam on manually.
Switching Adaptive Highbeam Assist on/off
The function can be activated/deactivated in the
Lights
menu under the
Exterior lighting
item in the multimedia system (
The Ô indicator lamp (grey) on the display
shows the driver that Highbeam Assist is active.
The Ô indicator lamp (blue) on the display
shows the driver that the high beam has been
automatically switched on by Highbeam Assist.
Combination switch
Using high beam / headlamp flashing
Switch on the ignition.
#
To switch on the high beam: switch on the
#
dipped beam L.
Press the combination switch in the direction
#
of arrow
The K indicator lamp on the instrument
cluster will light up.
Vehicles with Adaptive Highbeam Assist:
#
the high beam can be controlled automati‐
cally.
Switch on Adaptive Highbeam Assist Ô
#
(
/
Switch on the low beam L.
#
Press the combination switch in the direction
#
of arrow
The high beam will be switched on/off auto‐
matically depending on the situation.
The Ô indicator lamp (grey) on the instru‐
ment cluster will light up (when high beam is
OFF).
The Ô indicator lamp (blue) on the instru‐
ment cluster will light up (when high beam is
ON).
Headlamp flashing: pull the combination
#
switch in the direction of arrow
The K indicator lamp on the instrument
menu
cluster and the high beam will go on briefly.
page 75).
/
Using the turn signal indicators
To flash: push the combination switch
#
upwards to indicate right
indicate left
The corresponding turn signal lamps and
the , or . indicator lamp on the
instrument cluster will flash.
Driver cockpit
1
and allow it to engage there.
page 78).
1
and allow it to engage there.
1
or downwards to
2
until it engages.
79
2
briefly.
Advertisement
Table of Contents
