Table of Contents
Advertisement
freeze. Do not start the engine in this
case. Let the battery thaw first.
Do not connect the negative terminal
#
clamp of the jump lead to the vehicle
frame. Otherwise, engine or transmis‐
sion components may be damaged.
Observe the safety notes and protective meas‐
ures when handling the battery (
After jump-starting, have the batteries checked at
a qualified specialist workshop.
Make sure that the vehicles are not touching.
#
Apply the parking brake.
#
Switch off all electrical consumers.
#
Switch the ignition off.
#
Vehicles without a jump-starting connection
point
Connecting the jump lead
Remove the battery box cover (
#
First, connect the positive terminal clamp of
#
the jump lead to the positive terminal of the
other vehicle's battery and then to the q
positive terminal of the starter battery.
First, connect the negative terminal clamp of
#
the jump lead to the negative terminal of the
other vehicle's battery and then to the ±
negative terminal of the starter battery.
Assisting vehicle: run the engine at a high
#
speed.
Start the engine and let it run at idling speed.
#
Disconnecting the jump lead
First, disconnect the negative terminal
#
clamps of the jump lead from the negative
terminals.
Remove the positive terminal clamps of the
#
jump lead from the positive terminals.
Vehicles with a jump-starting connection
point
page 329).
/
Connecting the jump lead
First, connect the positive terminal clamp of
#
the jump lead to the positive terminal of the
other vehicle's battery.
Slide back the red protective cap with the
#
other positive terminal clamp of the jump
lead and connect the positive terminal clamp
to the q positive terminal.
First, connect the negative terminal clamp of
#
the jump lead to the negative terminal of the
other vehicle's battery.
Slide back the black protective cap with the
#
other negative terminal clamp of the jump
page 330).
/
lead and connect the negative terminal clamp
to the ± negative terminal.
Assisting vehicle: run the engine at a high
#
speed.
Start the engine and let it run at idling speed.
#
Disconnecting the jump lead
First, disconnect the negative terminal
#
clamps of the jump lead from the negative
terminals.
The black protective cap of the jump-start
connection point springs back into its original
position.
Remove the positive terminal clamps of the
#
jump lead from the positive terminals.
The red protective cap of the jump-start con‐
nection point springs back into its original
position.
Breakdown assistance 365
Advertisement
Table of Contents
