Table of Contents
Advertisement
46
Opening and closing
Draw back the curtains.
#
Close the outside flaps.
#
Detach/remove any loose objects in the cab,
#
e.g. mascots or coat hangers.
Priming ATA with interior protection
& WARNING Risk of becoming trapped
when closing a side window
When closing a side window, body parts could
be trapped in the closing area in the process.
When closing, make sure that no body
#
parts are in the closing area.
If someone is trapped, release the but‐
#
ton immediately or press the button in
order to reopen the side window.
& WARNING Risk of becoming trapped
while you are opening and closing the
sliding sunroof / pop-up roof
During opening and closing, parts of the body
could get caught in the sweep of the sliding
sunroof / pop-up roof.
During opening and closing, make sure
#
that no body parts are in the sweep of
the sliding sunroof / pop-up roof.
Release the button immediately if some‐
#
body becomes trapped.
or
Press the upper section of the button
#
again.
The closing process will be stopped.
Switch off the ignition or turn it to the radio
#
position.
Turn the integrated key to the locking position
#
in the door lock of the driver's door and hold
it for approximately two seconds.
Then turn the integrated key back to the rest
#
position and remove it.
or
Press the ß button on the key.
#
All turn signal lamps flash three times and the
indicator lamp in the , button flashes.
The vehicle is locked.
Vehicles with convenience central locking
system: the windows and the sliding sunroof/
pop-up roof close.
Priming ATA without interior protection
If persons or animals are to remain in the vehicle,
prime ATA without interior protection.
Switch off the ignition or turn it to the radio
#
position.
Briefly press the upper section of the ,
#
button.
The indicator lamp on the button will light up.
For the next locking operation, interior pro‐
tection remains deactivated.
Lock the vehicle with the integrated key or by
#
remote control.
or
Press the upper section of the , button
#
for longer than two seconds (not for the Neth‐
erlands).
The vehicle is locked and all turn signal lamps
flash three times.
ATA is primed.
If you switch on the ignition, ATA is deactivated
automatically.
Deactivating ATA/cancelling the alarm
Press the Ü button on the key.
#
or
If ATA was primed using the , button,
#
press the upper section of the , button
again for longer than two seconds (not for the
Netherlands).
All turn signal lamps flash once.
If you switch on the ignition, ATA is deactivated
automatically.
Triggering/deactivating the panic alarm
An alarm can be triggered manually with the
¨ button if danger threatens, for example.
Advertisement
Table of Contents
