Table of Contents
Advertisement
104 Driver cockpit
In the Pairing main menu, you can connect to a
vehicle for which you have already received
authorisation or add a new vehicle.
The vehicle functions in the My Truck main menu
are distributed across the three menus Dash‐
board, Truck and Remote.
Some of the functions can only be operated when
the ignition is switched on or the engine is run‐
ning. In this case, use the ignition run-on or
engine run-on functions (
/
The following is shown on the dashboard:
Total distance recorder and engine operating
R
hours
Levels of fuel and AdBlue
R
Outside temperature and interior temperature
R
(vehicles with automatic climate control)
Reservoir pressure in the brake circuits
R
Further information on fuel/AdBlue
range can be found in the "On-board computer
and displays" section.
Truck
Status display for outside flaps and the doors.
R
You can see whether the exterior flaps and
the doors are open or closed and whether the
vehicle is locked or unlocked.
If necessary, you can open or close the slid‐
ing sunroof/pop-up roof.
Display of axle loads and the gross vehicle
R
weight if the following conditions are fulfilled:
The vehicle is stationary
-
The driving level is active
-
The ignition is switched on, ignition run-on
-
function(
page 198)
/
Refer to the "On-board computer and display"
section for further information.
Tyre pressure, tyre temperature and battery
R
status of the tyre pressure sensors
Refer to the "On-board computer and dis‐
plays" section for further information on the
tyre pressure monitor.
Controls for the level control as with the on-
R
board computer if the ignition is switched on
(ignition run-on or engine run-on
(
page 198)).
/
Refer to the "On-board computer and display"
section for further information.
Bulb check
R
page 198).
Using the remote control you can operate the fol‐
lowing:
R
R
®
R
R
R
®
levels and
Refer to the body manufacturer's operating
instructions for further information.
Notes on the audio equipment (radio)
If you have fitted Mercedes-Benz audio equip‐
ment, you can operate your audio equipment as
follows:
R
R
R
If you fit audio equipment from another manufac‐
turer, you cannot use these functions.
Information on operating your audio equipment
can be found in the "CD radio" section
(
/
Dipped-beam headlamps, marker lamps, tail
lamps and licence plate lighting light up per‐
manently. Turn signals, main-beam head‐
lamps, brake lights, daytime driving lights,
reversing lamps, foglamps and working-area
lamps are switched on one after the other.
This cycle is repeated three times.
The bulb check can only be activated when
the parking brake is applied.
Unlocking and locking the loading tailgate
Switching the working area lamp on or off
Switching auxiliary heating on or off
(
page 110)
/
Switching the auxiliary air conditioning sys‐
tem on or off (
page 114)
/
Audio system
Activating/deactivating
-
Source selection
-
Station/track selection
-
Volume adjustment
-
Mute
-
with the buttons on the multifunction steering
wheel in the instrument cluster under the
Audio
menu
using the Truck app with a mobile device
(
page 103)
/
using the audio equipment button in the bed/
berth switch panel
page 155).
Advertisement
Table of Contents
