Replacing The Hydraulic Fluid Reservoir Cap; Parking Up The Vehicle; Operating Data Of The Hydraulic System; Hydraulic Fluid Quality - Mercedes-Benz Actros Operating Instructions Manual

Hide thumbs Also See for Actros:
Table of Contents

Advertisement

296 Driving mode
6
Max. fill level
226 l for 198 l used fluid quantity (usable vol‐
ume)
5
Distance
101 mm
7
Fill level
156 l for 128 l used fluid quantity (usable vol‐
ume)
5
Distance
258 mm
Approx. 4.5 l used fluid loss for every 10 mm the
surface level lowers
If necessary, top up with an authorised
#
hydraulic fluid through filter screen 2.
Before topping up, screw the filter screen into
the filler neck and then check the hydraulic
fluid level again.
Screw filter screen
2
into the filler neck.
#
Place cap with integrated vent filter
#
filler neck and fasten tightly.

Replacing the hydraulic fluid reservoir cap

Replace the hydraulic fluid reservoir cap every
year. In more dusty conditions you must change
the cap with integrated vent filter even more reg‐
ularly.

Parking up the vehicle

In addition to the special measures according to
Mercedes-Benz Specifications for Operating Flu‐
ids Sheet Number 382.0, a change of hydraulic
fluid must be carried out. After a non-operational
time of more than 24 months, a change of
hydraulic fluid must be carried out before restart‐
ing operation.

Operating data of the hydraulic system

Hydraulic fluid quality

The hydraulic system of the tractor/semitrailer
combination is filled at the factory with year-
round hydraulic fluid from H-LP (HLP-D 22).
Only use authorised hydraulic fluid with part
number A 000 989 10 06 according to the
Mercedes-Benz Specifications for Operating Flu‐
ids Sheet Number 341.0.
Hydraulic fluid reservoir
Combination tank with fuel tank on the left-
hand side of the vehicle
Fuel tank
Maximum tank con‐
tent
Maximum used fluid
quantity (usable vol‐
ume)
Non-usable dead vol‐
ume
Single tank on the right-hand side of the vehi‐
cle
Fuel tank
Maximum tank con‐
tent
Maximum used fluid
quantity (usable vol‐
ume)
Tank content for 128 l
1
on the
for used fluid quantity
(usable volume)
Non-usable dead vol‐
ume
%
As a single tank, the hydraulic fluid reservoir
is filled with 156 l of hydraulic fluid at the fac‐
tory.
Operating pressure and fluid output
Operating mode
High pressure oper‐
ation
Low pressure opera‐
tion
Volume
140 l
128 l
12 l
Volume
226 l
198 l
156 l
28 l
Pressure/fluid out‐
put
250 bar
170 bar

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arocs

Table of Contents