Table of Contents
Advertisement
54
Opening and closing
Retracting/extending the roller sunblind
Extending the roller sunblind
In the following situations, the roller sunblind will
perform a reference drive and be completely
retracted:
if the power supply has been interrupted, e.g.
R
following operation of the battery disconnect
switch
if the vehicle is exposed to an excessive load,
R
e.g. due to a pothole
Briefly press the § button.
#
The roller sunblind will extend as far as the
end position.
or
Press and hold the § button until the
#
roller sunblind has reached the desired posi‐
tion.
Retracting the roller sunblind
Briefly press the ¦ button.
#
The roller sunblind will retract as far as the
end position.
or
Press and hold the ¦ button until the
#
roller sunblind has reached the desired posi‐
tion.
%
If an error has occurred and you press a but‐
ton, the roller sunblind will carry out a refer‐
ence drive. The roller sunblind will be retrac‐
ted into the upper end position at a slower
speed than normal. The roller sunblind will
now be ready for normal operation.
If a reference drive is interrupted: press
#
the § button and then press the ¦ but‐
ton immediately afterwards. The roller sun‐
blind will be retracted into the upper end
position.
Advertisement
Table of Contents
