Table of Contents
Advertisement
58
Driver cockpit
Push lever
A
down and hold it in place.
R
Move the seat cushion or backrest into
R
the desired position by applying pressure
to or lifting your weight off it.
Release lever A.
R
Adjusting the seat backrest:
#
Lift your weight off the seat backrest.
R
Pull lever
A
up and hold it in place.
R
Move the seat backrest into the desired
R
position by applying pressure to or lifting
your weight off it.
Release lever A.
R
Adjusting the seat height: Pull lever
#
or push it down by one increment.
The seat will be raised or lowered by one
increment.
Switching on the seat heating: Press top
#
section
C
of the e switch.
The seat heating will be activated at the first
heating level
or
Press the bottom section
#
switch.
The seat heating will be activated at the sec‐
ond heating level.
Switching off the seat heating: Set switch
#
C
to the centre position.
Switching on the seat ventilation: Turn the
#
blower regulator s
D
the g position.
You can increase the airflow in three incre‐
ments.
Switching off the seat ventilation: Turn the
#
blower regulator s
D
top.
Adjusting the seat fore-and-aft position:
#
Pull lever
E
up and hold it in place.
R
Push the seat back/forwards until it is in
R
the desired position.
Release lever E.
R
Push the seat back or forwards until it
R
engages audibly.
Setting to rest position:
#
Pull lever
E
up and hold it in place.
R
Push the seat back as far as it will go.
R
B
up
%
#
C
of the d
%
downwards from
#
all the way to the
#
#
#
Lift lever
F
as well and push the seat
R
beyond the notch back into the rest posi‐
tion.
E
and F.
Release levers
R
By adjusting the seat fore-and-aft position,
you can slide the seat forwards into the drive
position again and lock it in place there.
You can prevent muscle tension using the
massage function.
Switching the massage function on/off:
Press button G.
When the massage function is switched on,
you will feel alternating upward and down‐
ward waves in the lumbar area of the seat
backrest. The separate air cushions in the
seat backrest will inflate and deflate in suc‐
cession for roughly ten minutes.
You can adjust the contour of the backrest
(lumbar support) and the side contours to
provide support for your spine.
Adjusting the seat backrest contour: Press
the top or bottom section of button K.
This will make the upper seat backrest con‐
tour firmer or softer.
Press the top or bottom section of button I.
This will make the lower seat backrest con‐
tour firmer or softer.
Press button H.
This will make the side contours firmer.
Press button J.
This will make the side contours softer.
Advertisement
Table of Contents
