Table of Contents
Advertisement
To Load a Configuration File
There are two configuration files you will be loading. One for the analyzer
CH0X._A, and one for the oscilloscope CH0X._B. For exercises that only use
the analyzer, you will only load the CH0X._A file. For exercises using the
scope, you will load both the CH0X._A and the CH0X._B files.
Place the flexible disk labeled "Logic Analyzer Training Kit
1
Configurations" in the disk drive.
Press the
System
MENU key.
2
Highlight the field to the right of
3
Choose
in the pop-up menu, and press the
Flexible Disk
Disk Menu is now displayed.
If the file directory has not been previously read by the logic analyzer, you
will see "reading directory . . ." before the directory listing is displayed.
Highlight the field below the
4
screen, then press the
then press the
key.
Done
See the figure on the next page if you need help.
Highlight the field to the right of
5
Highlight
in the pop-up menu, then press the
Analyzer
The procedure for loading a configuration file continues on the next page.
Using the knob, place the file name you want to load on the light gray
6
center line of the display.
Get other manuals https://www.bkmanuals.com
Setting the Jumpers and Loading the Configurations
System
, then press the
field, on the left side of the
System
Select
key. Highlight
Load
Load
, then press the
To Load a Configuration File
Select
key.
key. The
Done
in the pop-up menu,
Select
key.
key.
Done
11-5
Advertisement
Table of Contents
