Infineon Technologies CYPRESS Traveo Series Manual page 263

Page Section
29
6.Port Description
30
6.1 Port Description
161
8.Precautions and
Handling Devices
8.1.1.Precautions for
Product Design
165
8.Precautions and
Handling Devices
8.2.Handling Devices
Document Number: 002-10634 Rev. *J
Revised the below:
Error)
ADC Analog [0 to 63] input pin
Correct)
ADC Unit0 [ch.0 to ch.31] input pin
ADC Unit1 [ch.32 to ch.63] input pin
Revised the below:
Processing and Protection of Pins
Error)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause deterioration
within the device, and in extreme cases leads to permanent damage of the device. Try to prevent such
overvoltage or over-current conditions at the design stage.
Correct)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause deterioration
within the device and in extreme cases leads to permanent damage of the device. Try to prevent such
overvoltage or over-current conditions at the design stage.
Revised as below:
Correct)
Method to Switch Off VCC12 during Power-Off Sequence
During power-off sequence, it is necessary to switch off VCC12 by driving PSC1 pin low by entering PSS mode
(power domain 2 off). If VCC12 needs to be switched off by other means, RSTX needs to be asserted before
switching off VCC12 to inactivate the operation of VCC12 supplied domain below the operation assurance
range.
Change Results
S6J3350 Series
Page 262 of 307