Infineon Technologies CYPRESS Traveo Series Manual page 250

Page Section
161 8.Precautions and
Handling Devices
8.1.1Precautions for
Product Design
162 8.Precautions and
Handling Devices
8.1.2Precautions for
Package Mounting
165 9.Electric
Characteristics
9.1.1 Absolute
Maximum Rating
165 8.2Handling Devices Added Note of a function as below:
165 9.Electric
166 Characteristics
9.1.1 Absolute
Maximum Rating
167 9.Electric
Characteristics
9.1.1 Absolute
Maximum Rating
Document Number: 002-10634 Rev. *J
Revised as below:
Error)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause
deterioration within the device, and in extreme cases leads to permanent damage of the device. Try
to prevent such overvoltage or over-current conditions at the design stage.
Correct)
(1) Preventing Over-Voltage and Over-Current Conditions
Exposure to voltage or current levels in excess of maximum ratings at any pin is likely to cause
deterioration within the device and in extreme cases leads to permanent damage of the device. Try
to prevent such overvoltage or over-current conditions at the design stage.
Revised as below:
Error)
Surface Mount Type
Correct)
Surface Mount Type
Deleted Remarks comment as below:
Error)
Supply voltage
Operation assurance range, DV
Correct)
Power supply voltage, DV , Remarks ""
CC
Method to Switch off VCC12 during Power-off Sequence
During power-off sequence, it is necessary to switch off VCC12 by driving PSC1 pin low by entering
PSS mode (power domain 2 off). If VCC12 needs to be switched off by other means, RSTX needs
to be asserted before switching off VCC12 to inactivate the operation of VCC12 supplied domain
below the operation assurance range.
Added Note of a comment as below:
Maximum clamp current, Total maximum clamp current
Correct)
*13 VI or VO should never exceed the specified ratings. However, if the maximum current to/from an input is
limited by a suitable external resistor, the ICLAMP rating supersedes the VI rating.
Revised Warning of a comment as below:
Error)
Note:
− Application of stress (e.g., voltage, current, temperature) exceeding the absolute maximum rating may cause
damage to the semiconductor device. Therefore, make sure that nothing exceeds the rating.
Correct)
WARNING:
− Semiconductor devices may be permanently damaged by application of stress (including, without limitation,
voltage, current or temperature) in excess of absolute maximum ratings. Do not exceed any of these ratings.
Change Results
, Remarks "DV ≤V 5"
CC CC CC
S6J3350 Series
Page 249 of 307