Pci - Silicon Graphics Origin 300 User Manual

pci

007-4498-002
Use the other pbay commands as follows:
• Use the pbay dps command to view the status of all distributed power supplies or
an individual supply. The distributed power supplies are identified by a number
ranging from 1 to 6.
• Use the pbay dcport command to view the status of all DC output ports or an
individual DC port. The ports are identified by a number ranging from 1 to 8.
• Use the pbay fru command to view information about the power bay and DPS
FRUs. To view information about the power bay FRUs, use the number 0. To view
information about a distributed power supply FRU, use the numbers 1 through 6.
• Use the pbay reset command to reset the power bay and the power supplies.
• Use the pbay env command to view the status of the environmental monitoring
and to enable or disable environmental monitoring.
• Use the pbay init command to initialize communication with the power bay.
The pci set of commands displays the status of the PCI cards in an Origin 300 base
module or a PCI expansion module. For the PCI expansion module, this command set
also powers up, powers down, or resets a PCI card:
•
pci
• pci <u|d>
•
pci reset
• pci <bus> <u|d>
• pci <bus> reset
• pci <bus> <slot> <u|d>
• pci <bus> <slot> reset
In the pci command set, the mnemonic rst may replace the word reset.
L1 Controller Command Set
197