Log; Loopback - Silicon Graphics Origin 300 User Manual

log

loopback

007-4498-002
137.38.82.55 L0000123 perch
137.38.82.158 L0000018 shrimp
137.38.82.50 N0000001 sn2-dbg2
137.38.82.52 M0000114 snapper
137.38.82.157 L0000119 whale
The following log set of commands displays the contents of the log, resets the log, and
writes an entry into the log.
•
log
•
log reset
• log <entry>
Use the log command to view the contents of the log. If the log is empty, the output from
the log command is log is empty.
Use log reset to empty the log. Use log <entry> to write a line in the log. The variable
<entry> is text to enter in the log. Example C-52 shows sample output from the log
Start the Test command.
log Start the Test Command Output
Example C-52
L2>log Start the Test
log entry made.
Use the r <rack> s <slot> loopback <bytes> <count> command to test the L2-to-L1
connection. In this command, the variable <rack> is a rack number, the variable <slot> is
a slot number, the variable <bytes> is the number of bytes to send, and the variable
<count> is the number of times to run the test.
Note: For these commands, the words rack and slot may replace the mnemonics r
and s.
L2 Controller Command Set
009 1.7.7
018 1.7.7
022 1.7.7
015 1.7.7
008 1.7.7
213