Removing A Disk Drive - Silicon Graphics Origin 300 User Manual

3: System Operation

Removing a Disk Drive

68
To remove a disk drive, follow these steps:
1. If you are replacing a data drive, ensure that the drive has spun down before
removing it.
2. Open the bezel door as shown in Figure 3-12a.
3. Remove the drive by depressing its handle lock with your thumb and pulling the
handle away from the chassis until the handle disengages the drive connector from
the backplane connector (refer to Figure 3-12b).
4. Carefully slide the drive out of the bay (refer to Figure 3-12c) and place it on an
ESD-safe surface. Do not use the handle to pull the drive out of the bay.
5. Close the bezel door as shown in Figure 3-12d.
007-4498-002