Installing A Base Module In A Rack - Silicon Graphics Origin 300 User Manual

System with numalink module
Table of Contents

Advertisement

3: System Operation

Installing a Base Module in a Rack

78
To install a base module in the rack, follow these steps:
1.
Fully extend both the left and right slide rails from the rack until they lock into
place (refer to Figure 3-19).
2. Using two people, line up the chassis rails with the slide rails and slide the base
module into the rack until the safety latches stop the base module (refer to
Figure 3-19).
3. Press the safety latches on both sides of the base module and slide the base module
into the rack (refer to Figure 3-19).
4. Install the two screws that secure the base module to the front rails of the rack.
5. Install all of the cables at the rear of the base module.
6. Power on the system. For instructions on how to power on the system, refer to
"Powering On" on page 80.
007-4498-002

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Origin 300 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents