(Asterisk Character); Autopower; Brick - Silicon Graphics Origin 300 User Manual

C: System Controller Commands

* (asterisk character)

autopower

brick

178
Use the asterisk character (*) to broadcast a command. A command that is broadcast is
sent to the modules that are attached to the SGI Origin 300 base module that issued the
command. Example C-1 shows sample output from the * version command.
Example C-1 * version Command Output
001c20-L1>* version
001c20:
L1 1.8.l (Image A), Built 09/21/2001 13:06:33
001c22:
L1 1.7.17 (Image B), Built 09/12/2001 12:24:28
The following autopower set of commands enable, disable, and abort the feature that
enables the system to automatically power up if power is lost. This command also
displays the current autopower setting (refer to Example C-2).
•
autopower
•
autopower on
•
autopower off
•
autopower abort
autopower Command Output
Example C-2
001c20-L1>autopower
auto power on is disabled.
The following brick set of commands provides the status of modules and sets the
module location.
•
brick
• brick slot <slotnumber>
007-4498-002