Help - Silicon Graphics Origin 300 User Manual

help

007-4498-002
•
flash default old
•
flash default reset
Use the flash status command to view the status of the two firmware images stored
in flash memory. Example C-14 shows sample output from the flash status
command. Each image has a checksum value that indicates whether an image is valid.
flash status Command Output
Example C-14
001c20-L1>flash status
Flash image B currently booted
Image Status
----- -------------
A default
B valid
Use flash default <a|b> to set firmware image A or firmware image B as the default
image that the system controller uses when booting. The variable <a|b> is A or B. Use
flash default current to set the current image as the default flash image. Use
flash default new to set the new image as the default flash image. Use flash
default old to set the old image as the default flash image.
Use flash default reset to set the firmware image with the latest time stamp as the
default image that the system controller uses when booting. If the selected firmware
image is not valid, the flash default commands will return the following message:
cannot set default--image A (or B) is invalid!
The following help set of commands provides helpful information on the system
controller commands.
•
help
• help <command>
Use the help command to generate a list of all of the system controller commands. Use
the help <command> command to display more information on a single command. The
variable <command> is the name of a command.
Revision Built
---------- -----
1.8.1 09/21/2001 16:41:43
1.7.17 09/12/2001 12:24:28
L1 Controller Command Set
187