Silicon Graphics Origin 300 User Manual page 237

l1
007-4498-002
• ip <addr> <netmask>
• ip <addr> <netmask> <broadcast>
•
ip clear|reset
ip Command Output
Example C-47
ip
L2>
addr: 137.38.82.155
137.38.82.255
The l1 set of commands enters L1 mode or sends an L1 controller command to a
specified L1 controller. There are three commands in the l1 command set:
• r <rack> s <slot> l1
• r <rack> s <slot> l1 <cmd>
• :<port>:<l1> l1 <cmd>
Note: For these commands, the words rack and slot may replace the mnemonics r
and s.
Use the r <rack> s <slot> l1 command to engage the L1 command processor for the
specified rack and slot. In this command, the variable <rack> is a rack number and the
variable <slot> is a slot number. Example C-48 shows sample output from the
r <rack> s <slot> l1 command.
r <rack> s <slot> l1
Example C-48
L2> r 1 s 30 l1
entering L1 mode 001c30, <CTRL-T> to escape to L2
001c30-L1>
Use the r <rack> s <slot> l1 <cmd> command to send a command to a destination
module without changing the default destination value. In this command, the variable
<rack> is a rack number, the variable <slot> is a slot number, and the variable <cmd> is an
L1 controller command. Example C-49 shows sample output from the r <rack> s <slot>
l1 config command.
netmask: 255.255.255.0
Command Output
L2 Controller Command Set
broadcast addr:
211