Log - Silicon Graphics Origin 300 User Manual

C: System Controller Commands

log

192
The following log set of commands displays the contents of the log, resets the log, and
writes an entry into the log.
•
log
•
log reset
• log <entry>
Use the log command to view the contents of the log. If the log is empty, the output from
the log command is log is empty.
Use log reset to empty the log. Use log <entry> to write a line in the log. The variable
<entry> is text to enter in the log. Example C-21 shows sample output from the log
Start the Test command.
Example C-21 log Start the Test Command Output
001c20-L1>log Start the Test
log entry made.
007-4498-002