L2 Controller Command Set; Autopower; Config - Silicon Graphics Origin 300 User Manual

C: System Controller Commands

L2 Controller Command Set

autopower

config
206
The subsections that follow describe the L2 controller command set. The commands are
listed alphabetically and include examples of output where applicable.
The following autopower set of commands enable, disable, and abort the feature that
enables the system to automatically power up if power is lost. This command also
displays the current autopower setting (refer to Example C-40).
•
autopower
•
autopower on
•
autopower off
•
autopower abort
Example C-40 autopower Command Output
L2> autopower
auto power up appears disabled
The config set of commands displays the L2 controller configuration information.
There are five commands in the config command set:
•

config

•
config devices
•
config rescan
•
config auto
•
config manual
Note: For these commands, the mnemonic cfg may replace the word config.
007-4498-002