Uart; Usb; Figure C-2 Example Of Softreset Command Output - Silicon Graphics Origin 300 User Manual

C: System Controller Commands

uart

usb

204
Figure C-2 Example of
The uart set of commands displays the status of the following UARTs (universal
asynchronous receivers/transmitters): CTI, CTC, SMP, and Bedrock. This command also
enables you to reset the UART of the Bedrock ASIC.
•
uart
•
uart bedrock reset
Example C-37 shows sample output from the uart command.
uart Command Output
Example C-37
001c20-L1>uart
Baud Read
UART Rate State
---- ---- -----
CTI 107142 Discon
CTC 107142 Discon
SMP 37500 Discon
BED 57692 Connect Suspend 0
The usb command displays status information for the USB (universal serial bus) L1 port.
SSEs use this port to access L1 controllers in systems that do not have L2 controllers.
Example C-38 shows sample output from the usb command.
softreset Command Output
Read Read Read
Status Timeouts Breaks Errors State
------ -------- ------ ------ -----
Ready 0 0
Ready 0 0
Ready 0 0
0
Read Write Write
Status
------
0 Discon Ready
0 Discon Ready
1 Discon Ready
13 Connect Ready
Write
Timeouts
--------
0
0
0
0
007-4498-002