L2Find - Silicon Graphics Origin 300 User Manual

C: System Controller Commands
l2
l2find
212
r <rack> s <slot> l1 config
Example C-49
L2> r 1 s 28 l1 config
001r28:
:0 - 001r28
Use the :<port>:<li> l1 <cmd> command to send a command to a destination module
that does not have a brick identification number assigned to it yet. In this command, the
variable <port> is the port number, and the variable <cmd> is an L1 controller command.
Use the l2 command to engage and lock the L2 command processor. Example C-50
shows sample output from the l2 command.
Example C-50 l2 Command Output
L2> l2
L2 command processor engaged, <CTRL-D> for console mode.
The l2find command lists all of the L2 controllers that are connected together (refer to
Example C-51).
Example C-51 l2find Command Output
L2>l2find
13 L2's discovered:
IP SSN
--------------- -------- ---------------- ---- ------------
[ L2's with System Serial Number NOT set ]
137.38.82.101
137.38.82.102
[ L2's with different System Serial Numbers ]
137.38.82.156 L1000625
137.38.82.51 N1000405 itsys1
137.38.82.58 L0000002 klsys2
137.38.82.159 L0000138 klsys4
137.38.82.162 L0000005 klsys5
137.38.82.57 L0000007 klsys7
Command Output
NAME RACK FIRMWARE
000 L3 controlle
000 L3 controlle
001 1.8.0
111 1.7.7
002 1.7.7
004 1.7.9
005 1.7.7
007 1.8.0
007-4498-002