Reboot_L1; Reset; Router - Silicon Graphics Origin 300 User Manual

reboot_l1

reset

router

007-4498-002
Use power <up|down> to power on or power off all of the modules in the system. The
variable <up|down> is on or off. Use power vrm to check the VRM status.
The reboot_l1 set of commands reboots the L1 controller. The following commands
compose this set:
•
reboot_l1
• reboot_l1 <a|b|old|new>
Use the reboot_l1 command to reboot the L1 controller using the newest firmware
image (firmware image A or firmware image B). Use reboot_l1 <a|b> to reboot the
L1 controller using the specified firmware image. The variable <a|b> is a (firmware
image A) or b (firmware image B). Use reboot_l1 <new> to reboot the L1 controller
with a new A or B image. Use reboot_l1 <old> to reboot the L1 controller with an old
image.
Use the reset command to perform a reset of the system. After the L1 controller receives
a reset command, it sets various control and status signals back to their default values
and reboots the operating system. Example C-33 shows sample output for this
command.
reset Command Output
Example C-33
001c20-L1>reset
001c20-L1>
The router set of commands displays information about the NUMAlink module and
enables you to set the router type of this module. The NUMAlink module is an ordinary
router type. This command is valid for the NUMAlink module only.
•
router
•
router ordinary
L1 Controller Command Set
201