Select - Silicon Graphics Origin 300 User Manual

C: System Controller Commands

select

202
Example C-34 shows sample output from the router command.
Example C-34 router Command Output
001r28-L1>router
router type is ordinary
The following select set of commands displays and sets the mode of console I/O.
•
select
• select <rack> <slot>
•
select local
•
select ctc
•
select console
• select <a|b|c|d>
• select <subchannel>
• select filter <on|off>
Use the select command to view the current mode of console I/O. Example C-35
shows sample output from this command.
Example C-35 select Command Output
001c20-L1>select
console input: 001c20 console
console output: not filtered.
Use the other select commands as follows:
• Use select <rack> <slot> to set the rack and slot for console I/O.
• Use select local to set the system console to the local base module. The L1
controller will then identify the system to which to send console input. If filtering is
enabled, the L1 controller identifies the system for which to display output.
• Use select ctc to set the attached base module for console I/O.
• Use select console to set the mode of console I/O to console.
007-4498-002