Feed And Stacker Motor Removal; Sub-Sensor Circuit Board Removal; Lower Sensor Circuit Board Removal; Figure 4-16 Gear Box Motor Assembly Removal - JCM GLOBAL VEGA Series Operation And Maintenance Manual

Disassembly/Reassembly

Feed and Stacker Motor Removal

To remove the VEGA Unit's Feed and Stacker
Motors, proceed as follows:
1. Remove the three (3) Mounting Screws (Figure 4-
16 a through a ) retaining the Transport Gear
1 3
Box Assembly (Figure 4-16 b) to the Lower
Transport Assembly (Figure 4-16 c), and lift the
Transport Gear Box Assembly up and off the
Lower Transport Unit.
2. Remove the three (3) Mounting Screws (Figure 4-
16 d through d ) retaining the Stacker Gear Box
1 3
Assembly (Figure 4-16 e) to the Lower Transport
Unit, and lift the Stacker Gear Box Assembly up
and off the Lower Transport Unit.
Figure 4-16 Gear Box Motor Assembly
Removal
a
1
b

Figure 4-16 Gear Box Motor Assembly Removal

NOTE: Both Gear Box Assemblies are
identical. When reassembling the Gear Box
Assemblies, identify the Gears by the
labels located on each Box. Yellow label is
located on the Stacker Motor Housing
(Figure 4-16 f), and the White label is
located on the Feed Motor Housing (Figure
4-16 g).
3. Remove the two (2) Mounting Screws (Figure 4-
17 a & a ) retaining the Stacker Motor (Figure 4-
1 2
17 b) to Stacker Gear Box Assembly (Figure 4-17
c) and remove the Stacker Motor out of the
Stacker Gear Box.
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
a
2
d
2
d d
a
1 3
3
f
g e
c
Figure 4-17 Stacker & Feed Motor Removal
a
1
a
2
Figure 4-17 Stacker & Feed Motor Removal
Sub-Sensor Circuit Board
Removal
To remove the VEGA Unit's Sub-Sensor Circuit
Board, proceed as follows:
1. Unplug the single (1) Circuit Board Connector
(Figure 4-18 a) attached to the Sub-Sensor Board
(Figure 4-18 b).
2. Lift the Sub-Sensor Circuit Board and off the
Lower Transport Unit (Figure 4-18 c).

Figure 4-18 Sub-Sensor Board Removal

Figure 4-18 Sub-Sensor Board Removal
Lower Sensor Circuit Board
Removal
To remove the VEGA Unit's Lower Sensor Circuit
Board, proceed as follows:
1. Remove the two (2) Mounting Screws (Figure 4-
19 a & a ) retaining the Lower Sensor Board
1 2
(Figure 4-19 b) to the Carrier Base (Figure 4-19
c); then unplug the single (1) Circuit Board Con-
nector (Figure 4-19 d).
© 2016, JAPAN CASH MACHINE CO., LTD.
4 - 5
Section 4
b
c
b
a
c